GM Powertrain Unveils 3.6-Liter VVT Engine With Direct Injection - ModernCamaro.com - 5th Generation Camaro Enthusiasts
Automotive Industry News For General Auto Industry news other than Camaro.

 
LinkBack Thread Tools
post #1 of 6 Old 05-18-2006, 05:06 PM Thread Starter
Supporting Member
 
Join Date: May 2006
Posts: 178
 
GM Powertrain Unveils 3.6-Liter VVT Engine With Direct Injection

FOR RELEASE: 2006-05-18


GM Powertrain Unveils 3.6-Liter VVT Engine With Direct Injection
Latest offering promises significant horsepower and torque increases, dramatic hydrocarbon reductions, improved fuel economy


PONTIAC , Mich. – GM Powertrain announced today it will deliver a 3.6-liter V-6 gasoline engine with direct injection and variable valve timing (VVT) technologies in the 2008 model year. A vehicle application will be announced later in the year.

Additionally, it was forecast that by the end of 2008, GM will produce as many as 200,000 vehicles globally with direct injection technology, and by 2010, GM projects one out of every six GM vehicles in North America will be equipped with a direct injection engine.

The application of direct injection technology to the 3.6-liter VVT engine – a member of GM Powertrain’s family of high-feature V-6 powerplants used on cars and trucks around the world – contributes greatly to a 15-percent increase in horsepower over the current levels that range from 240 to 267; an 8-percent increase in torque, and up to a 3-percent improvement in brake-specific fuel consumption (BSFC). An approximate 25-percent reduction in cold-start hydrocarbon emissions is also achieved.

With direct injection, precisely metered fuel is delivered directly to the combustion chamber, which has a cooling effect in the chamber. Cooling the incoming air charge enables a higher compression ratio, which also improves engine efficiency. Less fuel is required to produce the equivalent horsepower of a conventional port injection combustion system.

“The 3.6-liter VVT with direct injection will be our highest specific output non-turbocharged V-6 engine, as well as one of the most fuel-efficient offerings in our high-feature family,” said Tim Cyrus, chief engineer for high feature V-6 and Northstar V-8 engines. “It’s the latest example of our strategy to continue to reduce emissions and improve fuel economy without sacrificing performance.”

This is GM’s third engine with gasoline direct injection. The announcement of the 3.6L VVT V-6 with direct injection comes on the heels of the introduction of GM Powertrain’s Ecotec 2.0-liter four-cylinder Turbo engine with direct injection on the 2007 Saturn Sky Red Line and Pontiac Solstice GXP roadsters. Also, since 2004, a naturally aspirated Ecotec 2.2-liter direct injection engine is equipped on Opel models in Europe.

How direct injection works

Direct injection differs from the fuel delivery process of a conventional engine by delivering fuel directly into the engine cylinder, where it is mixed with air. The combustion process of conventional fuel injected engines uses air and fuel that partially evaporates in the intake port or intake manifold prior to being introduced into the combustion chamber. Direct injection is a continuation of the evolutionary process of moving the fuel introduction point closer to the cylinder to improve control.

With the 3.6-liter VVT with direct injection, fuel is introduced directly to the cylinder during the intake stroke. As the piston approaches top-dead center, the mixture is ignited by the spark plug.

The fuel injectors are located beneath the intake ports. The intake ports only transfer air, unlike port fuel injection, which flows air and fuel, thus increasing efficiency. D irect injection also permits a slightly higher compression ratio than if the fuel were delivered with conventional fuel injection. The result is better fuel consumption at part and full throttle. The engine uses conventional spark plugs similar to other high-feature V6 engines.

A high-pressure, returnless fuel system is employed. It features a high-strength stainless steel fuel line that feeds a variable-pressure fuel rail. Direct injection requires higher fuel pressure than conventional fuel injected engines and an engine-driven high-pressure fuel pump is used to supply up to 1,740 psi (120 bar) of pressure. The system regulates lower fuel pressure at idle – approximately 508 psi (35 bar) and higher pressure at wide-open throttle. The exhaust cam-driven high-pressure pump works in conjunction with a conventional fuel tank-mounted supply pump.

Direct injection’s fuel delivery enables very efficient combustion to help reduce emissions, particularly on cold starts – the time when most tailpipe emissions are typically created. Also, direct injection permits a higher compression ratio – greater than 11.0:1 in the case of the 3.6 – which has a positive influence on fuel economy.

3.6-liter VVT DI
The 3.6-liter VVT DI is based on GM Powertrain’s sophisticated 60-degree dual overhead cam (DOHC) V-6 engine. It is the latest member of a growing family of GM Powertrain V-6 engines developed for applications around the world, drawing on the best practices and creative expertise of GM technical centers in Australia, Germany, North America and Sweden.
Features found on the 3.6-liter VVT DI include:
  • Aluminum engine block and cylinder heads
  • Dual overhead cams with four valves per cylinder and silent chain primary drive
  • High-pressure, engine-driven fuel pump
  • Advanced multi-outlet fuel injectors developed to withstand high pressure and heat
  • Stainless steel, variable pressure fuel rail
  • Four-cam phasing (VVT – see description below)
  • 11.3:1 compression ratio
  • Aluminum pistons with floating wrist pins and oil squirters
  • Polymer coated piston skirts
  • Forged steel crankshaft
  • Sinter-forged connecting rods
  • Structural cast-aluminum oil pan with steel baffles
  • Electronic throttle control with integrated cruise control
  • Coil-on-plug ignition
  • Advanced direct injection capable engine control module (ECM)
  • Optimized exhaust manifolds with close-coupled catalytic converters
  • Fully isolated composite camshaft covers
  • Outstanding noise, vibration and harshness control
  • Maximum durability with minimum maintenance
  • Common manufacturing practices for efficiency and exceptional quality
Four-cam phasing
The 3.6-liter V-6 VVT DI employs four-cam phasing to change the timing of valve operation as operating conditions such as rpm and engine load vary. The result is linear delivery of torque, with near-peak levels over a broad rpm range, and high specific output (maximum horsepower per liter of displacement) without sacrificing overall engine response and driveability. When combined, direct injection and cam phasing technologies enable an unmatched combination of power, efficiency and low-emissions in gasoline V-6 engines.

Cam phasing pays big dividends in reducing exhaust emissions by optimizing exhaust valve overlap and eliminating the need for a separate exhaust gas recirculation (EGR) system.

By closing the exhaust valves late at appropriate times, the cam phasers allow the engine to draw the desired amount of exhaust gas back into the combustion chamber, reducing unburned hydrocarbon emissions. The return of exhaust gases also decreases peak temperatures, which contributes to the reduction of oxides of nitrogen (NO x) emissions. In tandem with the dramatic 25-percent reduction in cold-start hydrocarbon emissions brought on by direct injection, the 3.6-liter VVT DI V-6 surpasses all emissions mandates, and does so without complex, weight-increasing emissions control systems such as EGR and air injection reaction (AIR).
http://www.media.gm.com/servlet/Gate...=3&docid=25970

Last edited by Chris 96 WS6; 05-18-2006 at 05:38 PM.
Chuggernaut is offline  
Sponsored Links
Advertisement
 
post #2 of 6 Old 05-19-2006, 06:35 AM
Senior Member
 
Gonna be a 5th gen owner's Avatar
 
Join Date: Mar 2006
Location: Dixon IL
Posts: 861
 
Garage
wow! sounds like the boys at gm are doing some serious homework! hopefully they will use this type of thinking when it becomes time to build the camaro and they use it on the v-8's
Gonna be a 5th gen owner is offline  
post #3 of 6 Old 05-19-2006, 12:19 PM
ModernCamaro.com Founder / Former Camaro Disciple
 
OctaneZ28's Avatar
 
Join Date: Jan 2006
Location: Chicagoland, IL
Posts: 11,842
           
A great powerplant!
Should make appearance in several vehicles, maybe including *ahem* something

2001 Camaro Z28 H/C/I LH6 A4 3.42

Like ModernCamaro.com on Facebook!
OctaneZ28 is offline  
 
post #4 of 6 Old 05-21-2006, 06:54 PM
 
Join Date: Jan 2006
Posts: 67
 
sounds complicated. should make for a great base engine for a pony car
Phoenix 5.7 is offline  
post #5 of 6 Old 08-09-2006, 11:34 AM
Member
 
gavin's Avatar
 
Join Date: Jul 2006
Posts: 455
 
WOW who knowes i may go buy a v6 camaro lol as long is puts out over 240hp LOL i drove my friends mom's MonteCarlo SS and it was pretty fast with 240hp so if this engine Gm is making puts out higher then 240 and gets great fuel ill buy it! and maybe do mods but **** sounds sweet!

Last edited by gavin; 08-09-2006 at 11:38 AM.
gavin is offline  
post #6 of 6 Old 08-17-2006, 11:08 PM
 
Join Date: Aug 2006
Posts: 10
 
God, If they put this in a new Camaro with a turbo I would literally crap my pants ... literally.
Turbofire is offline  
Sponsored Links
Advertisement
 
Reply

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the ModernCamaro.com - 5th Generation Camaro Enthusiasts forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome