2014 Z/28 manifolds
I bought these in an attempt to use them with turbos. They won't work without cutting and extensive rewelding of them. By the time that would be done, I'd be money ahead using ARH shorties.
They are too long for turbo use (turbos would hang too low).
They are low miles.
Perfect for someone in a communist state that can't use long tubes. It will take a little bit of fabrication to mate up to anything but a factory Z system because they terminate in a different location than LS3 exhaust manifolds.
Tube diameter is approximately 1.75"
Head side port is approximately 1.6" x 1.93"
Collector diameter is approximately 2.10"
Asking $450 OBRO shipped and insured.
Last edited by Blake-b; 12-24-2015 at 10:09 PM.