Thx guys, your the best
I've gone through 2 boards as of now, yikes (
) not 3, no metal touching
that I can see, the board sits in a plastic housing, that runs the water & Ice maker (dispenser's) .
the only other spot I see on them that are bad, is the two switch's that allows the Ice or water to run,
the male pugs to the switch's are black, instead of silver colored.
No, their is no water around the area of the entire board(s),
if your wondering, yea water is close but not one droplet to be found,
plus theirs a cover to keep water back from hitting the wafer board/control board.
This board makes the ice & water to come out, theirs a switch board further up from it
that allows you to to make changes to the ice (crush/cubed), light, 5-6 buttons to run
odd things, but its just a button board.