New Axle Back Center Exit Exhaust! Photo's!
Hey guys & gals, I just thought you might like to see a few photo's of a new Axle Back, center exit exhaust that I am fabricating for my 2010 2SS/RS L99 Camaro, from exhaust sections from a Borla XR1 system that I had left over from my 2003 ZO6 Corvette.
A good friend of mine owns a muffler shop, so I had no problems getting the ends of the exhaust sections expanded for slip fit connections where they were needed.
The system is made from 2 1/2 in. outside diameter .065 wall, 304 stainless steel tubing. I left the center resonator in the system to produce a chambered throaty exhaust note, which sounds fantastic all the way to red line with no drone.
The system will be finished off with two exhaust hangers & 4 in. diameter slash cut Borla tips to give it the Factory OEM look. The Factory exhaust outlet holes in the rear valance will be filled in using a valance from a previous Camaro that I once had.
You could also fabricate this system using exhaust sections available from stainless works with the endds expanded for slip fit connections as well! Feel free to pm me for questions. Enjoy the photo's.
All The Best,
Red 2010 Camaro