Modern Camaro Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter #1
OK so next week I may finally have some time to install the Hurst and skip shift elim.

From experience where is the best place, front and rear, to put a a floor jack and after getting it up to put the jack stands?

Up 'til now I have only had to get under lifted 4WD vehicles with actual frames and solid axles.

Thanx in advance.
 

·
Registered
Joined
·
134 Posts
Discussion Starter #3
Thanks, I looked at the owners' manual but had a hard time interpreting it.
 

·
Registered
Joined
·
75 Posts
Does one need a low profile jack (for the 5th Gen.), like a corvette? In the past I could get by with a regular jack with my 4th Gen.
 

·
Registered
Joined
·
472 Posts
I haven't looked at the jack points, and well, I don't have a spare tire anyway. :rolleyes:


Looking at that picture, the black areas right at the edge, in line with the supports shown, look to me to be the jack points.

If so, my stock 4th gen jack would operate flawlessly to lift the car there.
The 4th gen jack has a valley, but isn't wide enough that it would extend further underneath the car.
 

·
Registered
Joined
·
134 Posts
Discussion Starter #7
Yeah the edges are for the supplied jack, if you got it. You obviously would not want to put a floor jack there. That is why i wanted to see where persons are putting the lift points.
 
1 - 8 of 8 Posts
Top