Modern Camaro Forums banner

1 - 12 of 12 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1






pretty much harmless 2.8L v6 car or u would think until u take a second look



 

·
Registered
Joined
·
18 Posts
Discussion Starter #2










 

·
Registered
Joined
·
18 Posts
Discussion Starter #3

·
Registered
Joined
·
18 Posts
Discussion Starter #8
thnx guys ill have to post up pictures of some of the other things i built for the car
 

·
Registered
Joined
·
18 Posts
Discussion Starter #9
how about a custom sheetmetal plenum
whihc i have not run on this new motor yet when i ran it on the stock motor i picked up dam near 35 hp










 

·
Registered
Joined
·
18 Posts
Discussion Starter #10





 

·
Registered
Joined
·
18 Posts
Discussion Starter #11
custom 3/4 gallon fuel cell with pump for methonal or race gas for wet nitrous system


and these pics are from when it was unfinished so before u ask yes the pump holder has a real bracket to hold the pump,and the pump assembly bolts down to the lid with a seal









 

·
Registered
Joined
·
18 Posts
Discussion Starter #12
well i said screw the gt35r and am getting a deal on this instead


325 shipped new

full t4 with a .63 hotside with a 3 inch vband outlet p trim wheel
70mm compressor wheel with a 4 inch inlet and 2.5 outlet

and since the stock rods are only rated to 400 hp and 7k rpms they are already on borrowed time so .........

got a set of these on the way for when the new turbo goes on



paying 55 bucks each bushed for the smaller pins on the v6 pistons

gonna have to machine the big end width down .084 on one side to fit the v6 crankshaft but atleast i will get to use the surface grinder we have at the shop so it shouldnt be a big deal
 
1 - 12 of 12 Posts
Top