Modern Camaro Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
105 Posts
Discussion Starter · #1 ·
I had a little time today so I finished up the rear.











 

·
Premium Member
Joined
·
4,109 Posts
****, Charlie I have to say the underside of your G is cleaner than the top of most other cars. Were you able to install the bushings in the center section without removing it from the car? How many of these bushings require a press to be installed?
 

·
Registered
Joined
·
105 Posts
Discussion Starter · #3 ·
Most of the Pedders bushings are of a split design. 2 halves with a steel center. so you really just press them in by HAND. Now getting them out, well I have 250k in tools, so it wasnt too bad, but I did have to make the tool for the diff bushings. I just lowered the diff and put 10 shop towels under each axle so there was no way the inner axle could be damaged. I think the X frame and Diff bushings should be a must on any list.
 

·
Registered
Joined
·
105 Posts
Discussion Starter · #5 ·
I have been accused of being a little anal when it comes to detail, but my customers love it!
 
1 - 5 of 5 Posts
Top